Guide on Utilization of Eucalyptus and Acacia Plantations in China for Solid Wood Products

Guide on Utilization of Eucalyptus and Acacia Plantations in China for Solid Wood Products
I Eucalyptus citriodora
II Eucalyptus exserta
III Eucalyptus urophylla ×grandis
IV Eucalyptus grandis
V Eucalyptus urophylla
VI Eucalyptus cloeziana
VII Eucalyptus pellita
VIII Eucalyptus tereticornis
IX Eucalyptus mangium
X Acacia auriculiformis

Ⅰ Eucalyptus citnodora
1 WOOD PROPERTIES 1.1 Anatomical characteristics 1.2 Physical properties 1.3 Mechanical properties 1.4 Chemical properties
2 GROWTH STRESS
3 MACHINING PROPERTIES 3.1 Methods 3.2 Resuits and discussions 3.3 General conclusion　
4 SAWING TECHNIQUES 4.1 Strain in sawing process 4.2 BOW deformation. 4.3 Sawing inaccuracy 4.4 The influence ofend-splits on lumber recovery 4.5 Pilot sawing
5 DRYING TECHNIQUES 5.1 Air drying 5.2 Drying characteristics 5.3 Drying schedule 5.4 Pilot drying test
6 ADHESION PRoPERTIES
6.1 Finger joint 6.2 Gluing.

Ⅱ Eucalyptus exserta
1 WOOD PROPERTlES 1.1 Anatomical characteristics 1.2 Physical properties 1.3 Mechanical properties 1.4 Chemical properties
2 GROWTH STRESS
3 SAWING TECHNIQUES 3.1 Strain in sawing process 3.2 BOW deformation. 3.3 Sawing inaccuracy. 3.4 The influence ofend—splits on lumber recovery
4 DRYING TECHNIQUES 4.1 Air drying 4.2 Drying characteristics 4.3 Drying schedule
5 ADHESION PROPERTIES 5.1 Fingerjoint 5.2 Gluing

Ⅲ Eucalyptus urophylla×grandis
1 W00D PROPERTIES 1.1 Anatomical characteristics 1.2 Physical properties 1-3 Mechanical properties 1.4 Chemical properties
2 GROWTH STRESS
3 MACHINING PROPERTIES 3.1 Methods 3.2 Results and discussions 3.3 General conclusion
4 SAWING TECHNIQUES 4.1 Strain in sawing process 4.2 Bow deformation 4.3 Sawing inaccuracy 4.4 The influence of end-splits on lumber recovery
5 DRYING TECHNIQUES 5.1 Air drying 5.2 Drying characteristics 5-3 Drying schedule
6 ADHESION PROPERTIES 6.1 Fingerjoint 6.2 Materials 6 3 Method of experiments. 6 4 Result and discussion

Ⅳ Eucalyptus grandis
1 WOOD PROPERTIES 1.1 Anatomical characteristics 1.2 Physical properties 1.3 Mechanical properties 1.4 Chemical properties
2 GROWTH STRESS
3 SAWING TECHNIQUES 3.1 Strain in sawing process 3.2 Bow deformation 3.3 Sawing inaccuracy 3.4 The influence ofend-splits on lumber recovery　　……

Ⅴ Eucalyptus urophylla
Ⅵ Eucalyptus cloeziana
Ⅶ Eucalyptus pellita
Ⅷ Eucalyptus tereticornis
Ⅸ Acacia mangium
Ⅹ Acacia auriculiformis
REFERENCES
PLATE